TB 9-4940-321-30
shelf of work table in accordance with figure 27. Secure
5.
Installation--Continued
micrometer caliper set and counterbore set, using a 72-
in. retaining strap (7550588-1).
23.
Secure machine table vise to upright drilling
(18) Position surface plate (522000-516-3647)
machine, using furnished tee bolts and nuts.
on lower table shelf in accordance with figure 27.
Secure, using a 72-in. retaining strap (75505881).
(13) Position utility grinding machine (3415-00-
517-7754) on rear end of table top in accordance with
lower table shelf in accordance with figure 27. Wrap
figure 23. Using base of
utility grinding machine as a
extension light cords around center post of table to
template, mark and drill three 0.34-in. diameter holes
secure.
through table and storage cabinet tops. Secure to table
top, using three 5/16x 21/4-in. hex head capscrews
(19) Fabricate two cabinet roller base
(MS9072541), three 5/16-in. flat washers (MS2718311),
assemblies (11021203) in accordance with figures 36
thru 41. Fabricate shelf (11021202) in
accordance with
5/16-in. hex nuts (MS519675).
figure 34. Fabricate table top (11021200) in
accordance
with figure 32. Fabricate two support angles (11021208)
(14) Position work table (4910-00543-7772)
against front left wall in accordance with figure 23. Mark
and drill six 0.41-in. diameter holes in legs of work table
(20) Mark and drill four 0.62-in. diameter
(fig. 30), used for mounting work table in
deployed
clearance holes in bottom of two 20-drawer storage
mode. Secure each end of work table to wall in
cabinets (712500-999-1123) (two holes per storage
cabinet) in accordance with figure 27. Holes in storage
retaining straps (7550588-7).
cabinet bottoms must aline with four inserts (11021215)
located on cabinet roller base assemblies (11021203)
(15) Position tool kit (5180-00699-5273) on top
(two inserts per cabinet roller base assembly). See
Secure to wall, using a 92-in. retaining strap (7550588-
7).
(21) Position two 20-drawer storage cabinets
(16) Position mounting bracket of fire
assemblies (11021203). Position table top (11021200)
extinguisher (4210-00-555-8837) on front left corner wall
on top surface of two 20-drawer storage cabinets against
in accordance with figure 27. Mark and drill three 0.22-
in. diameter holes in mounting bracket. Position over
table top as a template, mark and drill four 0.34-in.
installed blind rivet nuts in accordance with figure 28.
diameter holes through storage cabinet tops. Secure
Secure mounting bracket to wall, using three #10 x 1/2-
front edge of table top to 20-drawer storage cabinets,
in. countersunk head machine screws (MS35190-271).
using four 5/16x 13/4-in. countersunk head machine
Install fire extinguisher in mounting bracket.
screws (MS35190-309), four 5/16-in.
(MS35338-45), and four 5/16-in. hex nuts (MS51967-5).
20