RELEASING SHELTER WALLS - CONTINUED
Extend support strut assemblies (Figure 1, Item 2) to their full length and insert pin (Figure 1, Item 1).
Using two personnel raise roof with support strut assemblies (Figure 1, Item 2) and set support strut assem-
blies (Figure 1, Item 2) in place.
Ensure hinged end walls do not hit Velcro straps to prevent damage.
Stencil on jack indicates handle rotation to raise or lower jack.
Removing Sidewall Support Braces.
Simultaneously lower hinged loor with hinged jacks until hinged end walls can swing freely.
Remove two sidewall support braces (Figure 2, Item 2) from Shelter BII box.
Install two sidewall support braces (Figure 2, Item 2) in brace cups marked "A" (Figure 2, Item 3) on hinged
loor and sidewall behind support cable (Figure 2, Item 1).
Place two ECU cables over each hinged end wall and secure cable ends to ECU screen.
Fold in each hinged end wall to roof beam and hold in place with Velcro straps.