0001 00
TM 1-4920-440-13&P
LIST OF ABBREVIATIONS/ACRONYMS CONTINUED
Term
Deinition Continued
PDB
Power Distribution Box
P DISE
PM
Preventive Maintenance
P/N
Part Number
PSI
Pound-force Per Square Inch
pt
Pint
PQDR
Product Quality Deiciency Report
REF
Reference
RPSTL
Repair Parts and Special Tools List
SECM
Shop Equipment Contact Maintenance
SMR
Source, Maintenance, and Recoverability
sq
Square
TAMMS
The Army Maintenance Management System
TAMMS-A
The Army Maintenance Management System Aviation
TASMG
Theater Aviation Sustainment Maintenance Group
TM
Technical Manual
TMDE
Test, Measurement, and Diagnostic Equipment
U/I
Unit of Issue
UUT
Unit Under Test
UOC
Usable on Code
UV
Ultraviolet
v
Volt
WCA
Warranty Claim Action
WP
Work Package
QUALITY OF MATERIAL
Material used for replacement, repair, or modiication must meet the requirements of this TM 1-4920-440-13&P,
Production/Quality Control Shop. If qualities of material requirements are not stated in this TM 1-4920-440-13&P,
Production/Quality Control Shop, the material must meet the requirements of the drawings, standards, specii-
cations, or approved engineering change proposals applicable to the subject equipment.
SAFETY, CARE, AND HANDLING
The following precautions should be exercised:
1.
Use extreme caution when performing procedures that involve the electrical system of this equipment.
High voltage exists and death on contact may result if personnel fail to observe safety precautions.
2.
Before performing continuity checks or replacing electrical components, ensure electrical power is dis-
connected completely from the circuit involved.
3.
In the event of a luorescent lamp breakage, care must be taken in the removal of broken glass frag-
ments and white phosphorous dust. Inhalation of phosphorous dust could cause serious injury.
4.
Do not use handling equipment with capacity of less than gross weight of shelter system. Do not allow
the shelter to swing back and forth when it is suspended. Failure to observe this warning may result in
damage to equipment or severe injury or death to personnel.
5.
Lock stop plate on load balancer with quick release pin before disconnecting support cable from hinged
loor.
6.
Expandable section (hinged loor and hinged sidewall together) weighs 700 pounds (318 kg). Do not
stand directly in front of hinged section.
0001 00-4