Explanations of Entries in the MAC
Columns (1) Group Number and (2) Component/Assembly. The functional groupings in the sample below
identify maintenance signiicant components, assemblies, subassemblies, and modules with the next higher
Servicing, handling inspection requirements, overhaul and retirement
schedules. External lines and hoses. (As applicable)
Rotor, blades, vanes, impeller, stators, inlet guide vanes, mainframe,
particle separator, bleed valve, bearings, seals, external lines, and hoses.
Liners, nozzles, stators, rotor, seals, couplings, and blades.
POWER-TURBINE (POWER TURBINE MODULE)
Nozzles, rotors, blades, exit guide vanes, exhaust frame, drive shaft,
bearings, seals, external lines, and hoses.
ACCESSORY GEAR BOX (ACCESSORY SECTION MODULE)
Input and output gears, seals, chip detector, housings, drive shaft, and
Fuel control, fuel boost pump, governors, fuel ilter assembly, sequence
valve, fuel manifold, fuel nozzle, external lines, and hoses.
Electrical control units, exciters, thermocouples, ignition harness, electrical
cables, history record, torque over speed sensor, Np sensor, external lines,
Tanks, oil ilter, oil cooler, lube and scavenger pumps, oil ilter bypass
sensor, external lines, and hoses.
Column (3) Maintenance Function. Entry lists the functions to be performed on the items listed in Compo-
Column (4) Maintenance Level. The maintenance levels ield and sustainment are listed on the MAC with indi-
vidual columns for AMC, ASB, TASMG, and Depot that include the work times for maintenance functions at each
maintenance level. Work time presentations such as "0.1" indicate the average time (expressed in manhours in
whole hours or decimals) it requires a maintenance level to perform a speciied maintenance function. If a work
time has not been established, the columnar presentation will indicate "--". Maintenance levels higher than the
level of maintenance indicated are authorized to perform the indicated function.
Column (5) Tools and Equipment Reference Code. Entry speciies, by code, those common tool sets (not indi-
vidual tools), common TMDE, and special tools, special TMDE, and special support equipment required to per-
form the designated function.
Column (6) Remarks Code. When applicable, this column contains a letter code, in alphabetical order, which
is keyed to the remarks.