3-23. Fixed Equipment/Components - Removal/Installation (Cont)
2. REMOVE/INSTALL BENCH TOP.
Permanently installed bench tops should not ordinarily be removed or
relocated. However, in the event that it becomes necessary to remove,
reinstall or replace them within the shelter, care must be taken to
remove all bolts, washers and nuts and save them for reuse. Two types
of bench tops are installed throughout the shop sets: 1) 30 inch width;
2) 60 inch width. These tops together with open bench legs are at-
tached in several configurations to the cabinets in the shop sets.
Remove all shop equipment from bench top IAW
Remove all lag bolts (1), lockwashers (2) and
washers (3) attaching bench top to cabinet.
Remove bench top (4).
If new bench top (4) is to be installed, proceed as
follows, otherwise proceed to Step e.
1) Obtain all mounting hole locations and dimen-
sions from old bench top (4).
2) Mark new bench top (4) for drilling using loca-
tions and dimensions obtained in Step 2.d.1.
3) Drill holes.
Align bench top (4) on cabinet and install lagbolts
(1), Iockwashers (2) and washers(3).
Align shop equipment over mounting holes and
install fastening hardware.
GO TO NEXT PAGE
3 - 3 4