3-23. Fixed Equipment/Components - Removal/Installation
This tasks covers: Removal/Installation of fixed equipment/components
Shop Set, Tool Crib, NSN 4920-00-472-4183
76C Shop Stock Clerk
1. REMOVE/INSTALL FIXED EQUIPMENT.
Permanently installed equipment should not ordinarily be removed or
relocated. However, in the event that it becomes necessary to remove,
reinstall or replace fixed equipment within the shelter, care must be
taken to remove all bolts, washers and nuts and save them for reuse.
a. Remove all bolts (1), lockwashers (2), washers (3)
and nuts (4) from shop equipment. Remove equip-
b. Install new or repaired equipment. If new equip-
ment has different mounting brackets, remount
equipment as follows:
Mark new mounting location on bench top.
Align shop equipment
c. Install bolts (1), lockwashers (2) washers (3) and
GO TO NEXT PAGE