LOWERING SHELTER ROOF
When all equipment and materiel is stored on stationary side of shelter,
limited floor space presents a safety hazard to personnel. This is most critical
during raising and lowering of roof panel. Personnel inside shelter could
become trapped between roof panel and equipment bolted to floor. Failure to
observe warning could result in SERIOUS INJURY to personnel.
A minimum of four personnel are required to perform all of the following
When swinging end wall closed, d-rings on ECU panel should be pressed flat
against panel to prevent damage to hinged roof.
1. Two personnel inside shelter, using support struts (1), will lower roof panel (2) until two personnel outside can
reach and hold weight of roof panel (2).