FIG. Column. This column lists the number of the figure where the item is identified/located in the repair
parts list and special tools list work Packages.
ITEM Column. The item number is the number assigned to the item as it appears in the figure referenced
in the adjacent figure number column.
UOC. The UOC appears in the lower left corner of the Description Column heading. Usable On Codes
are shown as "UOC: . . ." in the Description Column (justified left) on the first line under the applicable
item/nomenclature. None coded items are applicable to all models. Identification of the UOCs used in
this RPSTL are:
Model FPU-8/12-PARTS OD Olive Drab
Model FPU-8/12-BULK OD Olive Drab
Model FPU-8/12-PARTS DS Desert Sand
Model FPU-8/12-BULK DS Desert Sand
Fabrication Instructions. Bulk materiel required to manufacture items are listed in the bulk materiel
functional group of this RPSTL. Part numbers for bulk materiel are also referenced in the Description
Column of the line item entry for the item to be manufactured/fabricated. Detailed fabrication instructions
for items source coded to be manufactured or fabricated are found in: Not Applicable.
Index Numbers. Items which have the word BULK in the figure column will have an index number shown
in the item number column. This index number is a cross-reference between the NSN and P/N index work
Packages and the bulk materiel list in the repair parts list work Package.
Associated Publications. The publication(s) listed below pertain to the Authorized Stockage List Mobility
Operator's Manual, Generator Set, Skid Mounted, Tactical Quiet, 10 KW, 60
and 400 Hz
Unit, Direct Support and General Support Maintenance Manual for Generator
Set, Skid Mounted, Tactical Quiet
Illustrations List. The illustrations in this RPSTL contain unit and direct support authorized items. The
tabular list in the repair parts list work Package contains only those parts coded "O" and "F" in the third
position of the SMR code, therefore, there may be a break in the item number sequence.
HOW TO LOCATE REPAIR PARTS
1. When NSNs or P/Ns Are Not Known.
First. Using the table of contents, determine the assembly group to which the item belongs. This is
necessary since figures are prepared for assembly groups and subassembly groups, and lists are divided
into the same groups.
Second. Find the figure covering the functional group or the sub functional group to which the item
Third. Identify the item on the figure and note the number(s).