• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
SECTION II. SPECIAL TOOLS AND TEST EQUIPMENT - TM-5-4220-209-12P_233
SECTION IV. OPERATING INSTRUCTIONS

TM-5-4220-209-12P DMC-AA Air Compressor Modem 1C41-RDOW Part Number 83207 Manual
Page Navigation
  216    217    218    219    220  221  222    223    224    225    226  
SECTION III. PREPARATION FOR USE AND SHIPMENT 3-1. GENERAL.      The   Type   I   and   Type   II   Service Units are 157 inches (39876 mm) long, 73 inches (1854 mm)  wide,  66  inches  (1676  mm)  high  and  weighs  3280 lbs  (1478  Kg)  dry.    The  service  units  are  shipped  fully assembled,  however  there  are  certain  steps  which  shall be taken prior to placing the service units into operation. This   section   contains   step   by   step   procedures   to   be followed   when   preparing   the   unit   for   use,   storage,   or shipment 3-2. PREPARATION   FOR   USE.      To   prepare   the Service Units for use, proceed as follows a. Position   and   set   rear   stabilizing   jack   Remove any coating, blocking or protective maternal from service units. b To deprocess the service units, refer to applicable    DA    Form    2258,    Preservation    and Depreservation guide for Vehicles and Equipment. Pay  particular  attention  that  there  is  no break in the Oxygen Clean System of the Type II Service Unit c Inspect service units for any damage to gauges, meters, valves, loose connections or mountings, loose missing hardware, frayed or missing wiring on the M I  16A  I  Chassis,  or  any  other  damage Check   all   air/oxygen   tubing   and   flex   hose   for tight  connections  and  for  any  damage  that  may have    resulted    from    a    chaffing    condition    If damaged   tube   or   flex   hose   assembly   exists, replace the damaged Items as required. d. Close all control valves on the control panel e. Perform   procedures   contained   in   PRIOR   TO OPER-  ATION  (Section  IV)  and   INSPECTION AND  PREVEN-  TIVE  MAINTENANCE  (Section V), refer to Table 5-1 3-3. PREPARATION FOR STORAGE OR SHIPMENT.  Preparation  for  storage  or  shipment  of  the Servicing Unit shall be m  accordance  with  MIL-D-52838 (ME) 3-1/(3-2 blank)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.