Figure 5-4. Dehydrators
Place fresh cartridges/filters in the air
purification cylinders as follows (see Figure 8-2).
Screw the cap assembly until snugly in
cylinders. Apply enough force to cap assemblies to
pierce the cartridges with the built-in piercing blades.
After piercing blades have entered the cartridge, screw
cap assembly down firmly against the cylinder. Do Not
Figure 5-5. Engine Fuel Filter
Battery. To check the batterys state of charge,
proceed as follows:
Wear goggles to prevent electrolyte front
coming into contact with eyes. To
gloves and apron when filling battery.
To top up the battery, ordinary tap water
may be used except in areas known to have a high
mineral or alkali content in the water. In these areas,
distilled water shall be used.
The fluid level should be maintained at the
till to ring mark.