USING THE PORTABLE ELECTRIC SANDER
Select the proper attachment (1) and secure it to
the spindle (2) by depressing locking button (3)
and tightening spindle as shown.
Make sure the work surface (4) is secured to
Connect sander to power source. Depress
switch (5) on the sander so that the attachment
is turning before placing it on the work surface.
Using excessive pressure will slow
up the sanding action, clog the disk,
and cause motor to overheat.
With one hand on each handle (6) and (7),
begin sweeping the sander (8) back and forth
across the work surface.
During operation, tilt the sander slightly so the
entire disk does not contact the work surface.
Brush or clean the sanding dirt from the work
When finished, lift the sander from the work
surface before turning off the switch.