DESCRIPTION. A combination
lockwashers, securing the cylinder head shrouds to the
Flywheel forces air through the flywheel shroud to cir-
flywheel shroud, lower cylinder shrouds, rear shroud
c o v e r s , cylinder heat deflectors and remove the
culate around the cylinders and cylinder heads. Air
shrouds are provided to direct the flow of air.
cylinder head shrouds.
(2) Rear shroud covers.
Do not operate the engine with any part
secure the rear shroud covers to the cylinder heat
of the shrouding removed. To do so may
cause engine to overheat and be
(b) Remove the screws and lockwashers that
secure the lower cylinder shrouds to the rear shroud
covers. Remove the rear shroud covers.
(3) Lower cylinder shrouds.
(1) Cylinder head shrouds.
(a) Disconnect the spark plug cables from the
( b ) Remove the rectifier and regulator modules.
(1) Remove the screws and lockwashers that
secure each of the lower cylinder shrouds to the
secure the spark plug cable clips, the throttle control
flywheel shroud. Remove the lower cylinder shroud.
cable chips, and the screw and lockwashers securing the
ignition coil clamp. Remove the remaining screws and
b. Installation. Install in reverse order of removal.
Section XIV. MAINTENANCE OF CONTROL PANEL AND CUBICLE
4-26. CONTROL PANEL GUARD.
(1) Clean control panel guard with solvent and dry
a. Removal Loosen nine bolts and remove the con-
t.rol panel gaurd.
(2) Inspect control panel guard for holes, dents
b. Cleaning and Inspection.
and cracks. Replace a damaged control panel guard.