Table 3. Hardware-Continued
machine bolts 5306-225-9081 (use for securing legs
e. Unused space in the shop van may be utilized
over wheel well plates), four 5/16-18 x 2-inch
for transporting and storing other tools, etc.
h e x a g o n - h e a d machine bolts 5305-225-8504, six
f. One ground rod with cable assembly is in-
7 / 1 6 - i n c h hole diameter rectangular flat washers
cluded in the shop set for each shop van. Drive the
5310-209-0061 (place on underside of floor), six
ground rod into the ground and secure the cable
11/32-inch inside diameter flat washers 5310-
assembly to the chassis of the van each time the
0 8 1 - 4 2 1 9 , six 5/16-inch split lockwashers 5310-
shop set is placed in operation.
407-9566 and six 5/16-18 hexagon plain nuts
5310-880-7744.
3. Shop Van.
a. Work Tables (Figs 1, 2,
and 3)
(3) Place table (E) toward the rear of the van,
( 1 ) There are three work tables 4910-543-
f l u s h against the right side, and abutted against
7771, 4910-205-3046 and 4910-543-7772 to be
table (C) as shown in figures 1 and 2. Mark and
installed in the shop van. The tables in the sequence
drill six 11/32-inch holes through the floor of the
listed above, are designated A, C, and E.
van aligned with the mounting holes in the table
(2) Place work table (A) flush against the front
legs. Secure the table with four 5/16-18 x 1-1/4-
wall and left side of the van as shown in figure 1.
inch hexagon-head machine bolts 5306-225-9081
Locate table (C) on the right side of the van in a
(use for securing legs over wheel well plates), two
similar manner. Mark and drill twelve 11/32-inch
5/16-18 x 2-inch hexagon-head machine bolts
holes through the floor of the van aligned with the
5305-225-8504,
six
7/16-inch
hole
diameter
mounting holes in the table legs. Secure each table
rectangular flat washers 5310-209-0061 (place on
with two 5/16-18 x 1-1/4-inch hexagon-head
underside of floor), six 11/32-inch inside diameter
3