TM 1-4920-447-13&P3-23. Fixed Equipment/Components - Removal/lnstallation (Cont)3-232. REMOVE/INSTALL BENCH TOP.ab.c.d.NOTEPermanently installed bench tops should not ordinarily be removed orrelocated. However, in the event that it becomes necessary to remove,reinstall or replace them within the shelter, care must be taken toremove all bolts, washers and nuts and save them for reuse. Two typesof bench tops are installed throughout the shop sets: 1) 30 inch width;2)60 inch width. These tops together with open bench legs are at-tached in several configurations to the cabinets in the shop sets.Remove all shop equipment from bench top IAWStep 1.aRemove all lag bolts (1), Iockwashers (2) andwashers (3) attaching bench top to cabinetRemove bench top (4).If new bench top (4) is to be installed, proceed asfollows, otherwise proceed to Step e. 1) Obtain all mounting hole locations and dimen-sions from old bench top (4).2) Mark new bench top (4) for drilling using lma-tions and dimensions obtained in Step 2.d.13) Drill holes.e. Align bench top (4) on cabinet and install Iagbolts(1), lockwashers (2) and washers (3).f. Align shop equipment over mounting holes andinstall fastening hardware.GO TO NEXT PAGE3-34
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business