TM 10-5411-236-13&P
0053 00
5. Remove all wires on the topside of the distribution box.
6. Remove internal nuts (3) that attach the conduit.
7. Remove the four 1/4" 20 x 1" distribution box securing screws (4).
8. Pull distribution box down and remove.
9. Attach new distribution box with the four 1/4" 20 x 1" securing screws (4).
10. Feed wires and conduit through holes located in the top of the distribution box.
11. Install and tighten conduit nuts (3).
12. Attach wires in accordance with the above illustration.
13. Close and secure distribution box cover.
1
2
3
4
Replace distribution box "B" as follows:
1. Disconnect from power source.
2. Remove drawers/pallets/module to provide access to the area inside the container behind the
distribution box (refer to WPs 0006 00 and 0007 00).
3. Open distribution box (1).
4. Tag (from left to right) L1 (4), DC (5), L2 (6) and cut wires closely next to the receptacles.
5. Remove internal nuts (2) that attach the conduit.
0053 00-2
