TM 5-3610-256-14
ad. Reinstall left and right nylon bearings and secure with hex nut and washer.
ae. Reinstall spacers and air duct. Secure with hex nuts and washers.
af. Place cloths around right and left ends of lamp assembly and carefully insert assembly
from left end. Remove cloths.
ag. Secure lamp assembly on right end with wing nut. Reconnect right lamp connector.
ah. Tension belts by placing spring arm on left and right tension studs.
ai. Reinstall exhaust blower bracket. Reinstall blower assembly and secure with wing nuts.
Reconnect motor connector.
aj. Reinstall left and right covers and turn captive screws.
ak. Reinstall cylinder pick-off assembly on studs.
al. Plug in power cord.
am. Power ON.
an. Perform operational check.
5-13. MAINTENANCE OF THE SUPPLY CASE AND CARRYING CASE.
TOOLS: Flat-Tipped Screwdriver
Drill, 5/16-inch Bit
Rivet Gun
SUPPLIES: Strap Assembly
Wire Handle and Plate
Toggle Action Drawbolt
Backup Plates
Rivets
Washers
Support
Base
Cover
Carrying Case
Supply Case
a. If handles are defective, remove handle and backup plate by drilling out rivets with a
5/16-inch drill. Secure new handle and backup plate with rivets.
5-24
