TM 9-243
CHAPTER 2 SAFETY
SAFETY AND SAFETY EQUIPMENT
No matter how small the job, practice safety at all times.
A tool may be efficient, essential, time saving or even
convenient; but it is also dangerous. When using any
hand tool you must use it correctly, following the
methods prescribed in this manual. You must also be
alert for any conditions that might endanger yourself or
fellow workers. Take the time you need to learn the
safety guidelines in this chapter. Remember, you are
the most important part of safety procedures.
INDEX
Item
page
Safety rules (General) ..................
2-1
Tool habits ..................................
2-1
Safety rules (Power tools).............
2-3
Safety equipment.........................
2-3
Safety shoes................................
2-3
Eye protection..............................
2-4
Helmets ......................................
2-4
Gloves ........................................
2-4
Safety belts and safety straps.......
2-4
Ear protection ..............................
2-4
Section I. SAFETY RULES (GENERAL)
The shop area you work in will have a safety program to
follow. The following safety rules are furnished as a
guide.
1.
SUPPORT your local safety program and take an
active part in safety meetings.
2.
INSPECT tools and equipment for safe conditions
before starting work.
3.
ADVISE your supervisor promptly of any unsafe
conditions or practices.
4.
LEARN the safe way to do your job before you start.
5.
THINK safety, and ACT safety at all times
6.
OBEY safety rules and regulations-they are for your
protection.
7.
WEAR proper clothing and protective equipment.
8.
OPERATE
only
the
equipment
you
are
authorized to use.
9.
CONDUCT yourself properly at all times
10.
REPORT
any
injury
to
you
supervisor
immediately. Horseplay is prohibited.
11.
KEEP tools in a safe place. Never carry tools in
pockets or leave them lying around. Stepping
on a round screwdriver, for instance, could
cause a bad fall.
12.
CLEAN UP the work area when the job is
completed
13.
KNOW the location of all safety equipment and
be familiar with its operation.
In addition to the above rules, there are other habits that
will help you perform your work more efficiently as well
as more safely.
TOOL HABITS
Keep tools in their proper place
"A place for everything and everything in its place" is just common sense.
You cannot do an efficient, fast repair job if you have to stop and look
around for each tool that you need. The following rules, if applied, will
make your job easier.
Change 3 2-1
