TM 9-4933-223-13&P
e. Connection of Shop Set to Power Source.
(2) Push grounding rod (1) into the ground
near
mating
connector (4) on power distribution panel.
WARNING
NOTE
The electrical system contains voltages that are dangerous
if contacted. Before connecting or disconnecting power
Cable adapter assembly (5) is not needed if power
cables, ensure circuit breaker on power distribution panel
distribution panel is equipped with an MS90555 connector.
connected to power source is in OFF position.
(3) Connect plug connector (3) of cable adapter assembly (5) to
mating connector (4) on power distribution panel.
CAUTION
Be sure power source is 120/208-volt, 3phase, 60-Hz.
CAUTION
(1) Clamp wire of grounding rod (1) to terminal lug (2) of plug connector
Do not remove dust covers from connectors until just prior
(3).
to assembly with mating connector (4)
2-15