TB 9-3470-209-30
4.
Installation--Continued
for remaining three lampholder junction
boxes.
bows.
Install twelve box connectors
(Appleton 15233) in the junction boxes
(11) Install four grounded duplex
receptacles (5935-01-058-9269) after
and install jam nuts on box connectors
stripping 3 inches of outside insula-
tion from cable. Refer to
(8) Fabricate four power cable
from each individual wire and twist
assemblies (11021163, 11021164, 11021165,
wires to fit terminal lugs (MS20659-
and 11021166), using approximately 14
141).
Install terminal lugs and crimp.
Connect wires to grounded duplex
stall four box connectors (Appleton
receptacles to duplex junction boxes
for individual power cable construction,
with screws provided with grounded
and install in accordance with figures
14 thru 17.
(9) Install 28 feet of cable
(12) Install four duplex junction
(6145-00-295-1055) through duplex
box covers (Appleton 2510) to duplex
junction boxes and lampholder junction
boexes on second and fourth bows. Refer
secure with screws provided in duplex
junction box covers. Refer to figures
length of outside insulation from cable
15 and 16.
on inside of each junction box. Strip
1 inch of insulation from each individual
(13) Tighten al 1 box connectors
wire and twist wire to fit terminal lugs
(Appleton 15233) to secure flexible
(MS20659-141).
Install and crimp ter-
cords in junction boxes and switch box.
minal lugs in place in accordance with
(14) Secure power cable assemblies
(10) Connect three wires to lamp-
to bows and truck rack with twenty-
holder (GE-5740-7), and secure to
eight tiedown straps (MS3367-3) (fig.
lampholder junction box (Appleton 40-
14 thru 16).
3/4), with screws provided with lamp-
holder junction box. Repeat this step
12