AVIATION SHOP EQUIPMENT CONTACT MAINTENANCE (AV SECM) SYSTEM MAINTENANCE
INSTRUCTIONS FOR CURBSIDE ASSEMBLY - (CONTINUED)
Tap drilled holes using a 10-32 helical tap.
Install 10-32 helical into tapped holes.
END OF TASK
Prepare, prime and paint bare aluminum surfaces with Epoxy Primer Coating Kit and Epoxy Primer Coating
Kit, IAW MIL-STD-171.
It is only necessary to apply stencils to support plates that have been replaced.
Unless dimensions are stated, stencil locations are approximately applied as shown.
Bottom edge of stencil is to be placed centered at supplied measurement.
All stencils will be applied In Accordance With (IAW) MIL-DTL-53039, color is to be black
FED-STD-595 No. 37030.
Refer to WP 0021 for stenciling standards and speciications.