TM 10-5411-236-13&P
0051 00
6. Retighten hinge bolts using a 9/16-inch socket with ratchet and wrench.
7. Reopen the door to be aligned.
8. Loosen the hinge bolts using a 9/16-inch socket with ratchet and wrench on the door that is being
aligned. Do not loosen the hinge bolts on the door that the misaligned door is attached to.
9. Close the misaligned and opposite doors.
10. Retighten hinge bolts using a 9/16-inch socket with ratchet and wrench on the misaligned door.
Align doors 1, 4, 5, 6, 7, 10, 11 and 12 as follows:
1. Ensure that the container is on a level surface.
2. Remove drawers/pallets/modules directly behind the door to be aligned.
3. With door in the open position loosen hinge bolts on the door to be aligned using a 9/16-inch socket
with ratchet and wrench. Do not loosen the bolts on the hinges attached to the misaligned door.
4. Close the misaligned door leaving the opposite door open to allow access for measurements.
5. Using a pry bar, center door with equal distance from top of door edge to header and bottom door
edge to threshold.
6. Retighten hinge bolts using a 9/16-inch socket with ratchet and wrench.
REPLACE
Replacement of Door Hinge
1. Remove hinge bolts (1) using a 9/16-inch socket with ratchet and wrench, locknuts, and hinge (2) to
be replaced.
NOTE
Replace only one hinge at a time to avoid alignment problems.
1. Appling Locktite 262 red to the bolt threads, reinstall bolts (1), and replacement hinge (2).
2. Check door operation, alignment, and align as required.
Replacement of Door Assembly
Refer to schematics, description, and parts required in WP 0049 00. The primary components are the
hinges (1) carriage bolts (2) lock nuts (3) and seals.
Change 1
0051 00-2