TB 9-4940-319-30
Section I. INTRODUCTION
1.
General
Improper hook-up of Generator Sets
AN/MJQ-16 and 18 may result in a
a. Instructions contained in this bulletin are in
safety hazard to personnel and may
three sections. Section I contains the introduction and
damage equipment.
general instructions, warnings and cautions, and location
of equipment. Section II is a guide for installation of
CAUTION
welding shop equipment (NSN 4940-00-209-6240) in one
280 maintenance shelter, unit 1 (NSN 4940-00-919-
Special care should be exercised
8409) (fig. 1). Section III is a guide for installation of
during installation to avoid damage
welding shop equipment (NSN 4940-00-209-6240) in one
to electrical connectors, wiring, or
ISO-2-1 maintenance shelter, unit 2 (NSN 5411-01-124-
electrical equipment. To preserve its
1377) (fig. 6).
waterproof
characteristics,
precautions should be taken not to
b. Slight variations to the installation
puncture the outer skin when drilling
instructions may be made at the discretion of the officer
holes into the walls and floors of the
in charge.
shelters. The ISO-2-1 shelter must be
level prior to expanding the side. The
c. Complete lists of items contained in these
expanded portion of ISO-2-1 shelter
shops are found in SC 4940-95-CL-A64.
must be level to allow wall, roof, and
floor locks to engage. No equipment
d. Items not mentioned in this bulletin, that
shall be moved onto expanded floor
may be components of this shop, may be stowed in
until ISO-2-1 shelter is level.
storage cabinets and drawers or secured in such a
manner as to avoid damage in transit.
3.
Location of Equipment
e. All dimensions,
fastener
sizes,
and
a. location of equipment installed or stowed in
hardware sizes are in inches.
15.
f.
When entering either shelter, curbside is at
right and roadside is at left.
(1)
Refer to table 1 for hardware required
for installation.
2.
Warnings and Cautions
(2)
Refer to table 3 for components to be
WARNING
mounted.
All electrically powered tools and
b. Location of equipment installed or stowed in
equipment must be grounded prior to
use.
(1)
Refer to table 2 for hardware required
Extinguish all smoking materials and
for installation.
do not permit open flame or sparks
when using flammable cleaning
(2)
Refer to table 4 for components to be
solvent.
mounted.
c.
Refer to table 5 for standard conversion
chart.
1
