0052 00
TM 1-4920-436-13&P
REMOVAL CONTINUED
NON-METALLIC HOSE AND FITTINGS REMOVE CONTINUED
2.
Slit non-metallic hose (Figure 3, Item 4) lengthwise, with a utility knife (Figure 3, Item 3), from protective cap
(Figure 3, Item 2) to end of itting (Figure 3, Item 1); approximately 1 1/2 inches.
Figure 4.
Hose Removal.
3.
Bend non-metallic hose (Figure 4, Item 2) back over itting (Figure 4, Item 1) to remove.
4.
Repeat Steps 2 through 3 for opposite end of hose.
INSTALLATION
NON-METALLIC HOSE AND FITTINGS
Figure 5.
Hose Clamp Replacement.
1.
Slide loop clamps (Figure 5, Item 1) over new non-metallic hose (Figure 6, Item 2).
0052 00-4