TM 10-5411-236-13&P
0006 00
6.
Load constraint bars should be stowed on the floor under 12-inch parts drawers of the FPU-12P
container.
NOTE
Ensure lower receptacle is clean of debris before beginning this process.
OPERATING ADJUSTABLE DRAWERS (FPU-12 PARTS ONLY)
Adjustable drawer slide ledges have been installed in the FPU-12 parts container. These slide ledge
assemblies are attached to the vertical rack frame at two locations by four 5/16-inch Allen bolts at each
point of attachment. Drawers are mounted to these ledges by four bolts on each ledge.
All drawers are full extension and are operationally secured by locking rod handles to prevent opening
during transport or accidental closing during use. Drawers consist of fixed longitudinal dividers and
moveable transversal dividers that allow adjustment on two-inch centers. Drawers are rated with a
maximum capacity weight limit of 150 lbs per drawer.
CAUTION
Do not exceed maximum weight limit of 150 lbs per drawer. Exceeding load limits may
damage slide and drawer systems.
MOUNTING ALLEN BOLTS LOCATION
DRAWER SLIDE LEDGE ASSEMBLY
Opening and Closing Drawers (FPU-12 only)
WARNING
Container must be operated on level ground and periodically checked for shifting from a level
position. Use care when opening drawers, as physical injury may occur. To maintain control,
consider ground surface conditions that may not provide adequate traction, such as mud, snow,
ice, sand. Seek assistance from fellow soldiers to prevent impact or strain injury.
Change 1
0006 00-8