B-3
TM 10–6670-277–13&P
C . . . . . . . . . . . . . . . . . . . . .
O
. . . . . . . . . . . . . . . . . . . .
F . . . . . . . . . . . . . . . . . . . . .
H . . . . . . . . . . . . . . . . . . . . .
D . . . . . . . . . . . . . . . . . . . . .
Operator/Crew
Unit Maintenance
Direct Support Maintenance
General Support Maintenance
Depot Maintenance
e.
Column 5. Tools and Equipmen
.
t. Column 5 specifies, by code, those common tool sets (not
individual tools) and special tools, TMDE, and support equipment required to perform the designated
function.
f. Column 6. Remark. This
order, which shall be keyed to the
B-4. Explanation Of Columns
column shall, when applicable, contain a letter code, in alphabetic
remarks contained in section IV.
In Tool And Test Equipment Requirements, Section Ill.
a.
Column 1. Reference Code. The tool and test equipment reference code correlates with a code
used in the MAC, section II, column 5.
b.
Column 2. Maintenance Category.
The lowest category of maintenance authorized to use the tool
or test equipment.
c.
d.
e.
B–5.
a.
Column 3. Nomenclature. Name or identification of the tool or test equipment.
Column 4 . National Stock Number. The National stock number of the tool or test equipment.
Column 5, Too/ Number. The manufacturer’s part number.
Explanation Of Columns In Remarks, Section IV.
Column 1. Reference Code. The code recorded in column 6, Section Il.
Column 2. Remarks. This column lists information pertinent to the maintenance function being
b.
performed as indicated in the MAC, section Il.
(1)
GROUP
NUMBER
01
Section Il. MAINTENANCE ALLOCATION CHART
(2)
(3)
(4)
COMPONENT/
MAINTENANCE
MAINlTENAN CE
ASSEMBLY
FUNCTION
UN IT
DS
GS
C
O
F
H
ANALYTIC BALANCE
INSPECT
0.2
REPLACE
0.5
REPAIR
1.0
(5)
LEVEL
TOOLS AND
DEPOT
EQUIPMENT
D
1,2
(6)
REMARKS
