TM 5-3610-256-14
r. Reinstall left and right nylon bearings and secure with hex nut and washers.
s. Reinstall spacers and air duct. Secure with hex nuts and washers.
t. Place cloths around right and left ends of lamp assembly and carefully insert assembly from left
end, Remove cloths.
u. Secure lamp assembly on right end with wing nut. Reconnect right lamp connector.
v. Tension belts by placing spring arm on left and right tension studs.
w. Reinstall exhaust blower bracket. Reinstall blower assembly and secure with wing nuts.
Reconnect blower motor connector.
X. Reinstall left and right covers and turn captive screws.
y. Reinstall cylinder pick-off assembly on studs.
z. Plug in power cord.
aa. Power ON.
ab. Perform operational check.
4-23. REPLACE BALLAST TRANSFORMER.
TOOLS: Flat-Tipped Screwdriver
Multimeter
SUPPLIES: Ballast Transformer
Unplug power cord before servicing machine. Death
or injury may result from failure to comply with this
warning.
4-34
