TM 5-3610-256-14
CHAPTER 5
GENERAL SUPPORT MAINTENANCE
INSTRUCTIONS
Section
Page
General Support Maintenance Procedures . . . . . . . . . . . . . . . . . . . 5-3
Repair Parts, Special Tools, Test, Measurement, and Diagnostic . . . . . . . . . . . 5-1
Equipment, and Support Equipment
Troubleshooting Procedures . . . . . . . . . . . . . . . . . . . . . ...5-1
Section I. REPAIR PARTS, SPECIAL TOOLS, TEST, MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT , AND SUPPORT
EQUIPMENT
5-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to the
Modified Table of Organization and Equipment (MTOE) applicable to your unit.
5-2. TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT, AND SUPPORT EQUIPMENT. Test,
measurement, and diagnostic equipment, and support equipment are not required for the repair of this
equipment at the general support level of maintenance.
5-3. REPAIR PARTS AND SPECIAL TOOLS. Repair parts and special tools for this equipment are
listed and illustrated in TM 5-3610-256-24P (to be published).
Section Il. TROUBLESHOOTING PROCEDURES
5-4. TROUBLESHOOTING TABLE. Proper troubleshooting procedures require that preliminary
checks be accomplished, al I connections be tight and secure, and safeguards by utilized to prevent
excess ammonia vapor from entering the work area.
5-5. SCOPE. This manual cannot list all the possible malfunctions or every possible test, inspection,
or corrective action. If a malfunction is not Iisted or is not corrected by the listed corrective actions,
notify your supervisor.
5-1
