TM 5-3610-256-14
g. Remove four screws (2) and washers (3) and carefully withdraw the motor (6) from the equipment
h. Loosen brush assembly (1).
i. Remove brush caps and brush and holder assemblies.
j. Examine brush. If brush length is equal to or less than 0.25 inch (6.4 mm), replace the brush and
holder assembly.
k. Install brushes and holder assemblies and brush caps (1).
l. Reinstall motor with four screws and Iockwashers, and place gear on shaft. Secure the gear by
tightening the socket head setscrew over the flat portion of the shaft.
m. Reconnect motor leads.
n. Pull motor downward to restore chain tension. Tighten screws.
o. Reinstall rear cover and secure with screws.
p. Reinstall left cover and secure with captive screw.
q. Plug in power cord.
r. Power ON.
s. Perform operational check.
4-28
Change 4