TM
5-4940-200-25P
INTRODUCTION
Scope
3. Explanation of
Columns
The following provides an explanation of
This manual lists repair parts and special
tools required for the performance of organi-
through VI.
zational, direct support, general support, and
depot maintenance of the shop equipment.
a. Source, Maintenance, and Recoverability
Codes (SMR).
Note. Common hardware items known to be readily
a. The repair parts list is arranged as
available in Army supply channels will be assigned
follows:
Maintenance codes only. Source codes, Recoverability
(1) Individual parts and major assem-
codes, and Maintenance Allowances will not be as-
signed to this category.
blies are listed alphabetically by item name
within the numbered functional groups.
(1) Source Code. Indicates the selection
(2) Assembly components and subassem-
status and source for the listed item. Source
blies are indented and listed alphabetically by
codes used are:
item name under major assemblies.
Explanation
Code
b. This Repair Parts and Special Tools
P
Applied to repair parts which are stocked
List is divided into the following sections:
in or supplied from DSA/GSA or Army
(1) Prescribed Load Allowance (PLA)--
supply system, and authorized for use at
indicated categories.
M
Applied to repair parts which are not pro-
parts quantitatively allocated for initial stock-
cured or stocked but are to be manufac-
age at the organizational level. This is a man-
tured at indicated maintenance categories.
datory minimum stockage allowance.
A
Applied to assemblies which are not pro-
cured or stocked as such but made up of
repair parts authorized for the performance of
two or more units, each of which carry in-
dividual stock numbers and descriptions
maintenance at the organizational level.
and are procured and stocked and can be
(3) Special Tools, Test and Support
assembled by units at indicated mainte-
Equipment-Section IV. Not Applicable.
nance categories.
x
Applied to parts and assemblies which are
repair parts authorized for the performance of
not procured or stocked, the mortality of
which is normally below that of the ap-
maintenance at the direct support, general
plicable end item, and the failure of which
support, and depot level.
should result in retirement of the e n d
(5) Special Tools, Test and Support
item from the supply system.
Equipment-Section VI. Not Applicable.
X1
Applied to repair parts which are not pro-
(6) Federal Stock Number and Reference
cured or stocked, the requirement for which
will be supplied by use of the next higher
assembly or component.
al stock numbers followed by reference num-
X2
Applied to repair parts which are not
bers, appearing in all the listings, in as-
stocked. The indicated maintenance cate-
cending
cross-
alphanumeric
sequence
gory requiring such repair parts will at-
-referenced to index number.
tempt to obtain then through cannibaliza-
V