TM 55-4920-217-15
Section IV. OPERATION OF ONE UNIT IN CONJUNCTION WITH
ANOTHER ACCESSORY OR AUXILIARY
right rear corner of the van. This is a female receptacle,
73. General
designed to connect with a male plug.
Auxiliary equipment may be operated in conjunction
75. Quick Disconnect Fitting
with Shop Set, Aircraft Maintenance, Semitrailer
Mounted, C-8, Instrument Shop, by use of an external
The quick disconnect fitting (fig. 13), is designed to
power receptacle for electrical power and a quick
connect an external pneumatic power source to the
disconnect fitting for pneumatic power.
pneumatic system of the shop. An oil and water
separator is installed between the quick disconnect fitting
and the shop air lines to trap water or oil in the air from
74. External Power Receptacle
the power source.
The external power receptacle is mounted at the
Section V. OPERATION UNDER UNUSUAL CONDITIONS
used. Report recurrent failure of' the equipment resulting
76. General
from operation under unusual conditions on DA Form
This section contains information pertinent to second
468.
echelon maintenance operation of Shop Set, Aircraft
Maintenance, Semitrailer Mounted, C8, Instrument Shop,
77. Extreme Cold Weather Conditions
Special equipment is provided for the protection of
equipment in conditions (below 0F).
78. Extreme Hot Weather Conditions
extreme hot weather to insure proper operation. Refer to
79. Operation in Extreme Wet Climate
Inspect bearings and other lubricated surfaces for
possible washing away of lubricants. These inspections
should be made prior to starting and at halt of
equipment. Additional precautionary instructions for
operation in extremely wet climate are listed in
80. Operation in Salt Water Areas
Wash exterior of shop with fresh water to remove
salt water residue.
Accomplish salt water residue
Figure 29. Side panel installation.
removal as often as is necessary to
through 26 for additional information.
Install the
insulated side panels (fig. 29) when the equipment is
40