TM 55-4920-217-15
Tool and Equipment Drawer Location Instrument
and scorsby table are bench mounted (fig. 21). Typical
Semitrailer Mounted C-8-Continued.
mounting methods are shown in figures 30 through 34.
Storage
Drawer
Nomenclature
Total
No.
Qt
Tape, measuring
Tweezers, craftsman's
6
Curved Point
1
6
Hairspring
1
6
Hollow Jaw
1
6
Pivot Straightening
1
6
Slim Point
1
b. Location of Mounted Equipment.
In some
instances, tools, equipment, or instruments
are
mounted on walls, floor or benches of the shop.
These items are either too large for cabinet storage, or
their use makes cabinet storage impractical. Refer to
c. Separator, Water and Oil. The water and oil
separator is wall mounted as shown in figure 21.
Fabrication and mounting of the components are shown
in figures 15 and 16.
TYPICAL TURN TABLE MOUNTING
d. Bench Mounted Equipment. The drill press,
Figure 31. Typical turntable mounting.
instrument turn table, arbor press, 30 inch manometer,
e. Desk Chairs. Desk chairs are mounted on either
side of the shop (fig. 21). Typical mounting method is
shown in figures 35 and 36.
f. Jeweler's Bench.
The jeweler's bench is
mounted on the right side, center, of the shop (fig. 22).
Mounting and security devices are shown in figures 37
through 47.
g. Watchmaker's Lathe. The lathe is mounted on
top of the jeweler's bench (fig. 22). Mounting details are
shown in figure 48.
h. Altitude and Temperature Chamber. The altitude
and temperature chamber is mounted at the left center of
the shop (fig. 21). Mounting plates are shown in figures
Figure 30. Typical drill press mounting.
53
