TM 9-243
USING AN ADJUSTABLE OPEN-END WRENCH
1
Place the wrench (1) on the nut (2) so that the force
used to turn it is applied to the stationary jaw side of
the wrench.
2 Tighten the knurled adjusting nut (3) until the
wrench fits the nut as tightly as possible.
CAUTION
If the wrench does not fit tightly, it
will slip and round the corner of the
nut.
3
Swing the wrench clockwise to tighten the nut.
4
After the nut is tight, set it up (final tightening).
USING AN ADJUSTABLE STRAP PIPE WRENCH
1 Loop the strap (1) around the pipe (2) in the
opposite direction to that in which the pipe is to be
rotated.
2 Slip the end of the strap through the shackle (3) and
draw it up tightly.
3 Pull the handle (4) to turn the pipe in the desired
direction until the desired tightness is obtained.
NOTE
The jaw (5) at the end of the shackle
will seat against the strap and, as the
handle is pulled, the strap will
tighten and turn the pipe.
25-15
