TM 9-4933-223-13&P
MAINTENANCE PROCEDURES (cont)J
c. Detailed Procedures.
Contain an initial setup plus step-by-step
(1) Initial Setup. Is a list of everything needed in order to do the
procedures.
maintenance task:
(1) Initial Setup. Gives a list of everything needed in order to perform
Test Equipment--Lists all test equipment required to perform the
maintenance on each part of the shop set. See explanation of initial setup
maintenance procedures.
above. The only difference in an initial setup for a detailed procedure is that
there is no reference under equipment conditions to a maintenance
Special Tools--Lists tools needed to perform the maintenance
paragraph.
tasks.
(2) Step -By -Step Procedures.
Are illustrated procedures for
Materials/Parts--Lists expendable materials and 100% replaceable
maintenance authorized in the MAC, appendix B. For replacement of parts,
parts. Each material or part is followed by a part number. If more than one
part is needed, the quantity needed precedes the part number.
(a) Service upon receipt of the equipment--page 3-2.
Personnel Required--Lists the number of personnel needed and
what they will be doing.
(b) Troubleshooting--page 3-5.
References--Lists other publications, appendixes, and maintenance
REPAIR PARTS AND SPECIAL TOOLS LIST
procedures containing necessary
information.
a. Repair Parts and Special Tools. Designed for operator's and aviation
Troubleshooting References--Lists malfunctions which can be
corrected by following the maintenance procedure.
b. Parts List. Is composed of functional groups, and follows MAC order.
Parts in each group are listed in figure and item number sequence.
Equipment Conditions--Lists conditions to be met before starting the
procedure. The reference on the left of the condition is a page reference to
c. Illustrations. Illustrations and item numbers with repair parts
instructions for setting up the condition. At the end of each condition is a
authorized for operator's and aviation intermediate maintenance are in this
reference to the maintenance procedure to which the condition applies.
manual.
(2) List of Tasks. Summarizes in outline form the major tasks
involved in the procedure. Gives page references to troubleshooting table
and detailed procedures.
vi