TM 9-4933-223-13&P
Page
Page
Wiring Harness Assembly (Switch to Distribution
Ceiling Outlets)--Maintenance Instructions ...............................
Wire Assembly (Ceiling Outlets)--Maintenance Instructions......
Wiring Harness Assembly (Switchbox to Distribution Panel )--
Wire Assembly--Maintenance Instructions ................................
Maintenance Instructions ................................................
Wire Assembly (Switchbox)--Maintenance Instructions ...........
Section I. REPAIR PART SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Special tools are listed in appendix C of this manual.
3-1 COMMOM TOOLS AND EQUIPMENT
3-3. REPAIR PARTS
For authorized common tools and equipment refer to SC 4933-95-CL-A21.
Repair Parts are listed and illustrated in appendix c of this manual.
3-2 SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
No support equipment or TMDE is required for the shop set.
Section II. SERVICE UPON RECEIPT
3-4. SITE AND SHELTER REQUIREMENT
a. The ground shall be level and firm enough so that leveling jacks on
coupling assembly located on the exterior shelter wall to the left of the
the shelter can properly level the shop set.
personnel door.
b. A compressed air source must be supplied with a hose capable of
connection
to
the
male
quick-disconnect
c. An electrical power source must be furnished to provide 120/208-
volt, 3 phases, 60 Hz electrical power to the shelter.
3-2
