TM 9-4933-223-13&P
CONVERSION TABLE
NOTES
IN.
CM
0.31
0.79
1.
All dimensions shown are in inches. A dimension with a two-digit
decimal has a tolerance of 0.03 in. (0.08 cm) and a three-digit
0.1-
0.30
decimal has a tolerance of 0.005 in. (0.013 cm). All angles
0.312
0.792
have a tolerance of 1 degree.
0.406
1.031
46.940.06
119.230.15
21.000.06
53.340.15
2.
Fabricate from steel structural angle, NSN 9520-00-277-5987.
124.460.15
49.000.06
1.00
2.54
3.
Break all sharp edges and deburr all holes.
0.37
0.94
1.75
4.45
WARNING
0.85
2.16
Use only type 1.1.1 trichloroethane solvent. Never use
0.188
0.478
portable degreaser with solvent in it unless ventilation
fan is turned on. Breathing solvent vapors will cause
unconsciousness, prolonged skin contact with solvent will
cause irritation, and taking solvent internally will cause
vomiting.
4. Degrease with type 1.1.1 trichloroethane (item 1, app D).
5.
Apply one coat primer coating (item 14, app D), followed by two
coats semigloss OD enamel (item 7, app D).
6.
Mark with black stencil marking ink (item 17, app D) as follows.
P/N 12011664
Change 1 E-23
