TM 9-4940-547-14&P
Section 3.
MAINTENANCE
INSTRUCTIONS
3-1. Reference Instructions. Refer to TM 9-2330-238-14&P for instruc-
tions pertaining to service upon receipt of equipment, movement to a
new worksite, repair parts (special tools and equipment) and lubrica-
tion instructions for the shop sets. Refer to appendix A for instruc-
tions manuals.
3-2. Repair Parts. The following paragraphs/procedures refer to fig-
ures located in Section 4, Repair Parts List, page 4-1.
3-3.
Fire Extinguisher and Bracket.
a. General.
The fire extinguishers are mounted on the wall at the
front and rear of the van.
b.
Removal (fig 2 and 3).
(1) Release the latch and remove the fire extinguisher.
(2) Remove mounting hardware and bracket.
c.
Installation.
Install the fire extinguisher and bracket in
reverse order of removal, b above.
3-4.
First Aid Kit.
a. General.
The first aid kit is mounted on the wall in back of
the left side workbench.
b.
Removal (fig 2).
Release latch and remove the first aid kit.
c.
Installation.
Install kit in the reverse order of removal, b
above.
3-5. Data Plates.
The data plates are located on the rear door and
wall .
Removal.
a.
Refer to figure 2 and remove data plates.
b.
Cleaning,
Inspection and Repair.
WARNING
Dangerous chemical solvents are used with this equipment.
Avoid prolonged breathing of vapors; insure that there is
adequate ventilation at all times. Avoid skin contact.
Wash hands immediately after contact with solvent. If
solvent gets into your eyes, flush your eyes immediately
with clean water.
Seek medical attention if necessary.
(1) Clean data plates with cleaning solvent (P-D-680) and dry
thoroughly.
3-1
