TM 9-4940-547-14&P
(1) Clean all metal parts with cleaning solvent (P-D-680) and
dry thoroughly.
Clean other parts with a clean cloth.
Inspect items for cracks, breaks, bends, dents and other
(2)
damage.
(3) Check mounting hardware for damaged threads and distortion.
Replace damaged and missing hardware.
Remove nicks, burrs and distor-
(4)
Straighten bends and dents.
tions.
(5) Replace all items beyond repair.
Refer to figure 8 and reassemble the workbenches and
e. Assembly.
related parts.
Installation.
Install the left and right side workbench in the
f.
reverse order of removal, b above.
3-19.
Electrical Installation.
a. General.
Refer to TM 9-2330-238-14&P for repair instructions.
In addition, shop set componets not covered in above manual are
covered below.
Load Centers and Related Components.
b.
WARNING
Dangerous voltages, capable of causing death. are present in
this vehicle and the equipment provided in its tool load.
Use extreme caution when handling, testing or adjusting any
electrical component.
NOTE
Before removal and after installation test the wiring,
paragraph (2)(f) below.
(1) Removal and Disassembly. Refer to figures 9 through 16 to
disconnect, remove, and disassemble the electrical installation.
(2) Cleaning, Inspection and Repair.
(a)
Clean electrical parts with a clean dry cloth.
WARNING
Dangerous chemical solvents are used with this equipment.
Avoid prolonged breathing of vapors; insure that there is
adequate ventilation at all times. Avoid skin contact.
Wash hands immediately after contact with solvent. If
solvent gets into your eyes, flush your eyes immediately
with clean water.
Seek medical attention if necessary.
3-14
