TM 9-4940-547-14&P
b.
Removal (fig 6).
(1) Unfasten four straps (5) and remove the electronic cases.
(2) Remove sixteen each screws (6), nuts (7), washers (s), and
mounting bases (9).
c.
Install in reverse order of removal, b above.
Installation.
3-15.
Oscilloscope Electronic Case.
a. General.
The electronic case is located forward of the right
side workbench on the floor.
b. Removal (fig 6). Unfasten two straps (10) and one strap (11)
and remove electronic case.
c.
Installation.
Install in reverse order of removal, b above.
3-16.
DC Power Supply.
a. General.
The DC power supply is located forward of the left
side workbench on the floor.
Removal (fig 6).
b.
WARNING
Dangerous voltages, capable of causing death are present in
this vehicle, and the equipment provided in its tool load.
Use extreme caution when handling, testing, or adjusting any
electrical equipment.
(1) Shut-off power to the DC power supply in the circuit breaker
panel on the left rear interior wall (see fig 9).
(2) Remove four each screws (13), nuts (14), lockwasher (15),
flat washers (16), screws (17), lockwasher (18), and flat washers
(19).
(3)
Slide power supply forward and remove rear access panel (see
(4) Disconnect electrical connections and conduit, and remove
power supply (para 3-19).
Install in reverse order of removal, b above.
c.
Installation.
3-17.
Ground Rod and Upright Broom.
a. General.
The ground rod is mounted on the forward inner rail
of the right side workbench, and the broom on the left.
3-11
