TM 9-4940-547-14&P
b. Removal.
Refer to figure 4 and unfasten straps and remove
battery charger.
c.
Installation.
Refer to figure 4 and install battery charger
and secure straps.
3-12.
Machinist Vise.
a. General . The vise is located on top of the right side work-
bench above the battery charger.
b.
Removal (fig 4).
(1) Remove drawer number 13.
(2) Remove four nuts (4), four flatwashers (2), four lockwashers
(3) and four screws (l).
(3) Remove vise.
c.
Installation.
Install in reverse order of b above.
3-13.
Utility Grinding Machine.
a. General.
The grinding machine is located on the front of the
right side workbench.
b.
Removal.
(1) Remove drawer number 1.
WARNING
Dangerous voltages, capable of causing death are present in
this vehicle, and the equipment provided in its tool load.
Use extreme caution when handling, testing, or adjusting any
electrical equipment.
(2) Disconnect electrical power at circuit breaker #4 in power
panel (para 3-19).
(3) Remove two nuts (l), two lockwashers (2), two flatwashers
(3), and two screws (4) (fig 5).
(4) Disconnect electrical connections to grinder (para 3-19).
(5) Remove grinding machine (fig 5).
Install in reverse order of removal, b above.
Installation.
c.
3-14.
Frequency Convertor and Sweep Oscillator Electronic Cases.
The electronic cases are located on top of the left
a. General.
side workbench.
3-7
