TM 9-4940-549-14&P
Cleaning and Inspection.
b.
(1) Clean the air filters with cleaning solvent and blow dry with
low-pressure compressed air.
(2) Inspect filters for breaks, holes, cracks, and other defects and
replace a defective filter.
(3) Inspect filter gasket for defects and replace if defective.
Install the ventilating air filters and secure with nuts
Installation.
c.
and washers as illustrated in figure 13-1.
13-3. END WRAPPERS.
Remove the screws and nuts and end wrappers as illustrated
Removal.
a.
we 13-2.
Cleaning and Inspection.
b.
(1) Clean end wrappers in cleaning solvent and dry thoroughly.
(2) Inspect for defects, damage, and for loose or defective hard-
ware.
Install the end wrappers and screws and nuts as illus-
Installation.
C.
trated in figure 13-2.
Dynamotor-Welder End Wrappers, Removal and Installation.
