TB 9-4940-314-30
Section I. INTRODUCTION
1. General
CAUTION
a. The instructions contained in this bulletin are in
Special care should be
exercised during
three sections. Section I contains the introduction,
installation to avoid damage to electrical
warnings, and cautions, and general
instructions.
connectors, wiring, or electrical equipment.
Section II is a guide for installation of organizational fuel
and electrical shop shop equipment (NSN 4940-00-209-
To preserve its waterproof characteristics,
6228) in one 280 shelter unit 1 (NSN 4940-00-919-8409)
precautions should be taken not to puncture
the outer skin when drilling holes into floors
organizational fuel and electrical shop shop equipment
and walls of shelter.
(NSN 4940-00-209- 6228) in one ISO-2-1 shelter, unit 2
(NSN 5411-01-124-1377) (fig.13).
The ISO-2-1 shelter must be level prior to
expanding the side. The expanded portion of
b. Slight variations to the installation instructions may
the ISO-2-1 shelter must be level to allow wall,
be made at the discretion of the officer in charge.
rood, and floor locks to engage. No equipment
shall be moved onto the expanded floor until
c. Complete lists of items contained in these shops
ISO-2-1 shelter is level.
are found in SC 4940-95-CL-A53.
3. Location of Equipment
d. Personnel performing this installation should have
practical knowledge of electricity.
a. Location of equipment to be installed or stowed in
e. Items not mentioned in this bulletin, that may be
components of this bulletin, that may be components of
(1) refer to table 1 for hardware required for
this shop, may be stowed in storage cabinets and
installation.
drawers or secured in such a manner as to avoid
damage in transit.
(2) refer to table 3 for components to be
mounted.
f. All dimensions, fastener sizes, and hardware sizes
are in inches.
(3) Refer to table 5 for components to be
fabricated.
g. When entering either shelter through the one-man
door, curbside is at right and roadside is at left.
a. Location of equipment installed or stowed in ISO-2-
h.
1 shelter is referenced in figures 14 thru 20.
2. Warnings and Cautions
(1) Refer to table 2 for hardware required for
installation.
WARNING
All electricity powered tools and equipment
(2) Refer to table 4 for components to be
must be grounded prior to use.
mounted.
1
