TB 9-4940-316-30
Section I. INTRODUCTION
1.
General
CAUTION
To
preserve
its
waterproof
a. Instructions in this bulletin are in three
characteristics, precautions should
sections.
be taken not to puncture the outer
warnings and cautions, and location of equipment.
Section II is a
guide for installation of
small equipment
and floors of the shelters.
one 280 maintenance shelter, unit 1 (NSN 4940-00-919-
The ISO shelter must be level prior to
expanding the side. The expanded
small equipment repair shop shop equipment (NSN
portion of ISO shelter must be level
to allow wall, roof, and floor locks to
engage.
No equipment shall be
moved onto expanded floor until ISO
b. Slight variations to installation instructions
shelter is level.
may be made at the discretion of the officer in charge.
3.
Location of Equipment
c. Complete lists of items contained in this
shop are found in SC 4940-95-CL-A57.
a. Location of equipment installed or stowed in
d. Items not mentioned in this bulletin, that may
be components of this shop, may be stowed in storage
(1) Refer to table 1 for hardware required
cabinets and drawers or secured in such a manner as to
for installation.
avoid damage in transit.
(2) Refer to table 3 for components to be
e. All dimensions, fasteners, and hardware
mounted.
sizes are in inches.
(3) Refer to table 5 for a list of items to be
f. When entering either shelter, curbside is at
fabricated.
the right and roadside is at the left.
b. Location of equipment installed or stowed in
2.
Warnings and Cautions
WARNING
(1) Refer to table 2 for hardware required
for installation.
All electrically powered tools and
equipment must be grounded prior to
(2) Refer to table 4 for components to
use.
mounted.
CAUTION
(3) Refer to table 6 for a list of items to be
fabricated.
Special care should be exercised
during installation to avoid damage
c.
Refer to table 7 for standard conversion
to electrical connectors, wiring, or
chart.
electrical equipment.
1