TB 9-4940-316-30
3.
Location of Equipment--Continued
Table 6. Components to be Fabricated for ISO Shelter
Figure
Size
Qty
Description
no.
0.75 x 20.00 x
1
BENCH TOP-11021209, BENELEX
88.00 L
14 GA x 18.00 x
1
SHELF-11021210, SHEET STEEL
40.00 L
2.00 x 2.00 x
2
SUPPORT ANGLE-11021208, ALUMINUM
0.25 x 21.50 L
Section II. INSTALLATION IN 280 SHELTER
diameter holes in left wall in accordance with figure 9.
Install six #10 blind rivet nuts (MS27130-A23).
4.
Installation
NOTE
(2)
Mark and drill twenty 0.42-in.
diameter holes in floor and walls in accordance with
Hand blind riveter (5120-00-679-6523)
is used to install 679-6523) is used to
(MS27130-A45).
install blind rivet nuts in floor and
walls.
Install blind rivet nuts in
b.
Follow steps 1 thru 21 below for
accordance with the technical manual
equipment installation in the 2 shelter, unit 1.
supplied with the hand blind riveter.
(1)
Fabricate eight angle up-right
Positioned floor mounted equipment
members,, twenty angle cross members, twenty angle
as shown in figures 2, 3, 4, 5, and 9.
rear members, and twelve angle front members in
Use the equipment mounting holes
accordance with figure 11. Fabricate eight rack shelves
as a template for location of blind
in accordance with figure 12. Assemble two rack
rivet nuts in accordance with figures
assemblies without rack shelves on left side in
accordance with figures 2, 9, and 10, using eighty-eight
first aid kit and fire extinguisher as
5/16- x 5/8-in. pan head machine screws (MS35206-
295), eighty-eight 5/16-in. lockwashers (MS35338-45),
shown in figure 9, using the
and eighty-eight 5/16 in. hex nuts (MS51967-5).
equipment mounting holes as a
template for location of blind rivet
nuts.
(2)
Mark and drill eight 0.33-in.
diameter clearance holes (four for each rack assembly)
a. Follow steps 1 and 2 for installing blind rivet
in angle front and rear members in accordance with
nuts.
(1) Mark and drill six 0.25-in.
8
