TB 9-4940-316-30
figure 2 Position over installed blind rivet nuts in
(7)
Using right-hand bench support
accordance with figure 3. Secure rack assemblies to
as template, mark and drill two 0.33-in. diameter holes in
floor using eight 5/16x 1-in. hex head capscrews
side of 20drawer cabinet in accordance with figure 5
(MS90725-34), eight 5/16-in. flat washers (AN970-5),
and eight 5/16-in lockwashers (MS35338-45). Install
(8)
Secure a right-hand bench
eight rack shelves in racks, starting with rack angles 15
support to 20-drawer cabinet (fig. 5) using two 5/16x 7/8-
inches above the floor in accordance with figure 9.
in. pan head machine screws (MS35206-297), two
(3)
Position mounting bracket of fire
nuts (MS51967-5). Secure right-hand bench support
extinguisher (4210-00-555-8837) on left wall in
over the installed blind rivet nuts on floor, using two
accordance with figure 9. Mark and drill three 0.22-in.
5/16x 1-in. hex head capscrews (MS90725-34) and two
diameter holes in mounting bracket. Position over
5/16-in lockwashers (MS35338-45)
installed blind rivet nuts and secure mounting bracket to
wall using three #10 x 1/2-in. countersunk head machine
(9)
Position
10-drawer
cabinet
screws (MS35190-271).
Install fire extinguisher in
(7125-00-999-1122) on right side of shelter in
with 10-drawer cabinet using left-hand bench support,
(4)
Before installing first aid kit
two 5/16x 7/8-in. pan head machine screws (MS35206-
297), four 5/16-in. lockwashers (MIS35338-45), two 5/16-
0.22-in. diameter holes in back of case. Position case in
in. hex nuts (MS51967-5), and two 5/16x 1-in. hex head
location shown in figure 9, over installed blind rivet nuts.
capscrews (MS90725-34)
Secure case to wall using three #10 x 1/2-in
countersunk head machine screws (MS35190271).
(10)
Position
right-hand
bench
Install contents of first aid kit. (See also fig. 2.)
support on right side of 10-drawer cabinet (fig. 5) over
installed blind rivet nuts in floor. Secure right-hand
(5)
Fabricate a front brace angle
bench support to floor, using two 5/16x 1-in. hex head
and a rear brace angle in accordance with figure 6.
capscrews (HS90725-34) and two 5/16-in. lockwashers
Fabricate two right hand bench supports, a left-hand
(MS3533845)
bench support, a shelf, and a shelf support in
CAUTION
Make sure cabinet drawers adjacent
(6)
Position
one-compartment
to hole locations are removed before
cabinet (7125-00-991-2857) and 20-drawer cabinet
(11)
Using right-hand bench support
as template, mark and drill two 0.33-in. diameter holes in
CAUTION
side of 10drawer cabinet
Make sure cabinet drawers adjacent
to hole locations are removed before
(12)
Position shelf between rear wall
and 10-drawer cabinet over installed blind rivet nuts in
using shelf support (fig. 5), two 5/16- x 7/8-in. pan head
9