D E P A R T M E N T OF THE ARMY TECHNICAL BULLETIN
SHOP SET, SMALL ARMS : FIELD MAINTENANCE
(5180-754-0664) : INSTALLATION IN 2-TON
SHOP-VAN TRUCK M109 OR M220
Headquartes, Department of the Army, Washington 25, D.C.
25 July 1961
Paragraph Page
G e n e r a l ---------------------------------------------------------------------------------------- 1
Shop
Set---------------------------------------------------------------------------------------
Installation of Shop Equipment ------------------------------------------------------------------ 3
undercoating compound similar to that used on
the underside of the vehicles.
are to be used as a guide for ordnance Corps
Field Maintenance personnel responsible for the
installation of SHOP SET, SMALL ARMS: Field
SET: Field Maintenance, Small Arms, such as
Maintenance 5180-754-0664.
benches, vises, electric drill, and bench grinder
must be firmly secured within the shop-van (fig. 1).
b. These instructions can be followed as pre-
scribed in most instances. However, installation
Components of the hardware kit required for
of the shop set in vehicles and equipment of
mounting this shop set are listed in table I. The
different manufacturers may require minor
items to be mounted in the shop van are listad in
changes. Equipment may be installed in loca-
b. Each shop set will be mountad in 2 ton 6 by
tions other than specified herein when justified by
work requirements.
6 Shop-Van Truck M109 or M220.
c. A complete list of items contained in this
Caution: Do not drill holes through cross mem-
shop set is included in SM 9-4-5180-A18, SHOP
bers or into frames of vehicles or tables. If
SET, SMALL ARMS: Field Maintenance 5180-
necessary, move the item to be mounted slightly
754-0664. The hardware kit 5340-753-3500 will
so that drilled holes will avoid these structures.
be listed in SM 9-4-5180-A18 and its component
c. Ground all electrically powered equipment
in SM 9-4-5340-S01.
mounted in the shop-van to the chassis of the
d. Items not mentioned in this bulletin that
vehicle as a safety precaution against electrical
are components of the aforementioned shop set,
shock to the operator.
may be stowed in table drawers or other con-
venient places, in such a manner as to avoid
the van for transportation purposes only and is to
damage in transit.
be removed from the van before operation.
body of the shop-van to insure that the waterproof,
characteristic of the body are retained. All
tables 4910-543-7771 to be installed in the front
hardware extending through the floor of the van
of the shop van. Place one work table, against
should have the outer parts covered with paint or
the right wall and 1 inch from the front wall of the
*This
bulletin
supersedes
TB
ORD
444-4,
10
June
1952.
TAGO
565A-Aug.
6104466-61
