TM 1-4920-435-13&P
0042 00
REMOVAL CONTINUED
FOUR DRAWER CABINET (A) (SC4920-99-A68) OR SIX DRAWER CABINET (A) (1035658) CONTINUED
4.
Remove four lag bolts (Figure 3, Item 1), four lock washers (Figure 3, Item 2), and four lat washers (Figure 3,
Item 3) detaching work surface (Figure 3, Item 4) from cabinet (A) (Figure 3, Item 5).
5.
Remove work surface (Figure 3, Item 4) from top of cabinet (A) (Figure 3, Item 5).
6.
Remove four bolts (Figure 3, Item 8), eight lat washers (Figure 3, Item 7), four lock washers (Figure 3, Item
2), and four nuts (Figure 3, Item 6) detaching two cabinet brackets (Figure 3, Item 9) from cabinet (A) (Figure
3, Item 5).
REPAIR OR REPLACEMENT
FOUR DRAWER CABINET (A) (SC4920-99-A68) OR SIX DRAWER CABINET (A) (1035658)
1.
If cabinet brackets (Figure 3, Item 9) can be repaired by welding, weld damaged area IAW TM 1-1500-204-23.
Repair must not interfere with form, it, or function of cabinet brackets (Figure 3, Item 9).
2.
Paint repaired cabinet brackets (Figure 3, Item 9) IAW WP 0068 00, Figure 5.
INSTALLATION
FOUR DRAWER CABINET (A) (SC4920-99-A68) OR SIX DRAWER CABINET (A) (1035658)
1.
If a new work surface (Figure 3, Item 4) must be installed:
a.
Position work surface (Figure 3, Item 4), inished side up, on top of cabinet (A) (Figure 3, Item 5).
b.
Ensure work surface (Figure 3, Item 4) is lush with back, left and right sides of cabinet (A) (Figure 3, Item
5) with a two inch overhang on the front side of cabinet (A) (Figure 3, Item 5).
c.
On inside of cabinet (A) (Figure 3, Item 5), mark four hole placements (Figure 3, Item 10) in top of cabinet
(A) (Figure 3, Item 5) on non-inished side of work surface (Figure 3, Item 4).
d.
After four hole placement marks have been made, lip work surface (Figure 3, Item 4) over with non-
inished side up.
e.
On non-inished side of work surface (Figure 3, Item 4) at four marked hole placements, center punch
and drill four 5/16 inch holes to a depth of 3/4 inch.
f.
Return work surface (Figure 3, Item 4) inished side up, on top of cabinet (A) (Figure 3, Item 5).
g.
Align bolt holes of work surface (Figure 3, Item 4) with bolt holes on top of cabinet (A) (Figure 3, Item 5).
h.
Install four lag bolts (Figure 3, Item 1), four lock washers (Figure 3, Item 2), and four lat washers (Figure
3, Item 3) securing work surface (Figure 3, Item 4) to cabinet (A) (Figure 3, Item 5).
2.
Install hardware attaching cabinet (A) Figure 3, Item 5) to shelter wall and loor (WP 0043 00, Cabinet (A)
Hardware, INSTALLATION ).
3.
Install drawers, slides, and shelves as necessary (Drawers, Slides, And Shelves, INSTALLATION).
4.
Install kick plate (Kick Plate, INSTALLATION).
0042 00-5