TM 1-4920-500-13&P
0006 00
INSTALLING AREA LIGHT
NOTES
Do not remove area light wing nuts from screws.
When area light is installed at cargo end of shelter, cable is routed over top
of shelter. Excess cable slack should be neatly coiled on area light post so
that it does not present a hazard to personnel.
3
2
1
10
11
5
4
6
9
8
7
SSAE030
1. Remove area light (3) from inside fixed personnel end wall (10) by loosening, NOT removing, two wing nuts
(4) and sliding mounting screws (5) out of mounting brackets (6).
2. Remove bulb from shelter BII box (WP 0002, Figure 2, Item 12) and twist into light socket.
3. Unroll area light cable (8).
4. Install area light (3) on outside of fixed personnel or cargo end wall by sliding mounting screws (5) into
mounting brackets (6).
5. Secure area light (3) to mounting brackets (6) by tightening two wing nuts (4) on area light (3).
6. Remove protective dust cap (9) from either "J3" or "J4" (1 or 2) connector on power entry panel (7).
7. Remove protective dust cap (9) from area light cable (8).
8. Connect area light cable (8) into "J3" or "J4" connector (1 or 2) on power entry panel (7) and secure with lock
ring (11).
End of Work Package
