TM 1-4920-500-13&P
ARMAMENT AND ELECTRICAL SHOP
MAINTENANCE INSTRUCTIONS FOR OIL/WATER SEPARATOR
INITIAL SETUP
Tools And Special Tools:
References:
Torque Wrench 0-600 in. lbs.
(WP 0041 00, Table 2, Item 102)
Equipment Conditions:
Utility Knife
Functional
(WP 0042 00, Table 2, Item 108)
Materials/Parts:
Oil/Water Separator
(WP 0044 00, Figure 26, Item 1)
Hex Head Bolt (WP 0044 00, Figure 26, Item 2)
Lock Washer (WP 0044 00, Figure 26, Item 3)
Flat Washer (WP 0044 00, Figure 26, Item 4)
Pipe Bushing (WP 0044 00, Figure 26, Item 5)
Pipe Nipple (WP 0044 00, Figure 26, Item 6)
Pipe Coupling (WP 0044 00, Figure 26, Item 7)
Pipe Elbow (WP 0044 00, Figure 26, Item 8)
Hose Fitting (WP 0044 00, Figure 26, Item 9)
Non-Metallic Hose
(WP 0044 00, Figure 26, Item 10)
Loop Clamp (WP 0044 00, Figure 26, Item 11)
Personnel Required: (1)
CMF 15 Series
WARNING
Ensure compressed air supply is disconnected before attempting any work on
oil/water separator. Do not direct compressed air near eyes or directly against
skin. Wear goggles; high pressure air against eyes can cause BLINDNESS.
NOTE
During installation of components same hardware should be used so as to
maintain original integrity of shop set.
0037 00-1