0017
TM 1-4920-924-13&P
AVIATION SHOP EQUIPMENT CONTACT MAINTENANCE (AV SECM) SYSTEM MAINTENANCE
INSTRUCTIONS FOR LED FLEXIBLE TABLE LAMP - (CONTINUED)
INSTALL
NOTE
If mounting holes for the LED lexible table lamp are not damaged, reinstall LED lexible table
lamp using existing holes. If holes for the LED lexible table lamp were damaged
If holes for the LED lexible table lamp were damaged it may be necessary to add or subtract
1/2 inch to the measurement below to avoid using damaged holes. Keep LED lexible table
lamp lush with back of work bench assembly and as centered as possible.
1.
On top surface of butcher block table top (Figure 1, Item 3) measure on back, right to left 20.75 inches
and mark measurement.
2.
Position right edge of LED lexible table lamp (Figure 1, Item 1) at marked measurement and ensure LED
lexible table lamp (Figure 1, Item 1) is lush with back edge of butcher block table top (Figure 1, Item 3).
3.
Center punch four mounting holes of LED lexible table lamp (Figure 1, Item 1) onto butcher block table
top (Figure 1, Item 3).
4.
Remove LED lexible table lamp (Figure 1, Item 1) and drill one 1/8 inch hole at each center punched mark.
5.
Remove debris from butcher block table top (Figure 1, Item 3) and secure LED lexible table lamp
(Figure 1, Item 1) by installing four #8 X 1.50 inch wood screws (Figure 1, Item 2).
6.
Connect LED lexible table lamp (Figure 1, Item 1) power cord to electrical plug.
END OF TASK
END OF WORK PACKAGE
00172
