TM 1-4940-355-12&P
0016 00
Replacing Door Seal
1. Remove old door seal (9 or 10) from door (5 or 6).
2. Remove old adhesive, oxidation, dirt, and /or other contaminates from door seal area.
3. Rough sand door seal seat area with 100 Grit Paper, (Item 6, WP 0031 00) or similar to prepare surface for
adhesive.
5. Apply Permabond Cyanoacrylate (Superglue) Adhesive, (Item 2, WP 0031 00) in a continuous bead on front,
back, and edge of door seal seat area.
6. Place new seal on door and hold in place for approximately 3 to 5 minutes to allow adhesive to set.
TOUCH-UP PAINTING
WARNING
Chemical agent resistant coating (CARC) is extremely toxic and flammable.
Never use where sparks, smoking or open flame may be present. CARC, if
improperly used, may cause long term health problems. Avoid contact with skin,
breathing of fumes, or ingestion of dried particles. Use must be monitored by
local safety office and preventive medicine support activity. Refer to TM 43-0139
for applicable safety precautions prior to removal or application of CARC.
1. Prime surfaces with MIL-P-23377, Primer (Item 8, WP 0031 00) and paint with MIL-C-22750, Number 34094
(Green 383) (Item 9, WP 0031 00) in accordance with TM 43-0139.
ASSEMBLY
NOTE
The following steps should be performed on each door.
1. Attach 2 blocks (14) to top and bottom on insides of door (5 or 6) using 8 rivets (16).
2. Attach D-ring lock (12) to door (5 or 6) using 4 rivets (15).
3. Insert 2 rods (13) into inside of D-ring lock (12) and twist 1/4 turn locking rods in D-ring lock.
4. Turn D-ring lock handle (12) allowing rods (13) to be inserted into blocks (14).
5. Return D-ring lock handle (12) to resting position.
6. Tighten locking bolts (11) to secure rods (13).
7. Attach hinge (4) to door (5 or 6) using 10 rivets (3).
8. Attach door (5 or 6) to Main Box Assembly using 10 rivets (3) through hinge (4).
9. If door seal (9 or 10) has been removed, complete steps 2 through 6 in Replacing Door Seal above.
10. Attach hasp (2) on left door (5) with 3 rivets (1) and staple (2) on right door (6) with 4 rivets (1).
11. Attach doorstop (8) to left door (5) using 11 rivets (7).
12. Seal all outside joints, seams, bolts and rivet heads with Number 8802 extrudable sealant (Item 4, WP 0031
End Of Work Package
0016 00-3/(4 Blank)